CureZone   Log On   Join
Re: SilverLungs Generator
BrightSideOfLife Views: 2,154
Published: 7 years ago
This is a reply to # 2,336,023

Re: SilverLungs Generator
It is inside the zip file download 1.8 MiB inside the Hardware folder as a pdf called silver_generator_v1_schematic.pdf

ATM I cannot afford any further time tonight as I am trying to find the parts I need for a basic generator which I want to get ordered tonight. Otherwise I will not get the parts before the weekend which is already going to be difficult. I will look for the research when I can find some time but it will probably not be until next week as I have so much to get done besides the normal health maintenance which burns my time.

Current is meant to be dependant on electrode surface area, the greater the area the higher the current. I have seen 0.0011mA/mm^2 for 24 VDC which is meant to produce good quality CS. 0.0015mA/mm^2 for higher voltages eg 48 VDC and larger batches. I am thinking about using 30 VDC.

Did Esstee post a formula for working this out? I could not find it when searching. I am thinking about getting 1 meter (3+ft) of 12 gauge silver 99.99% wire which works out most cost effective for surface area when compared with lower gauge wire and shorter lengths. I am planning on reusing the electrodes if I do build that generator, however my post to his blog has disappeared, it was awaiting moderation, so I might not bother.

Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


Donate to CureZone

CureZone Newsletter is distributed in partnership with

Contact Us - Advertise - Stats

Copyright 1999 - 2023

1.109 sec, (1)