CureZone   Log On   Join
Problem with the original Clark zapper super de luxe
 

Original Hulda Clark
Hulda Clark Cleanses



Your Ad Here
Place your ad here !



J.Crow’s® Lugol’s Iodine
Free S&H.Restore lost reserves.J.CROW’S®Lugol’s Iodine Solut...


More
engavi Views: 8,060
Published: 13 years ago
 

Problem with the original Clark zapper super de luxe


Hello to the forum

I purchased an original clark zapper de luxe 2006 and following the instructions of management, always gives the message "no load" after a few seconds of "start".
The wristband is moist and well-connected to the zapper.
I note with the oscilloscope wave output that is not always positive (as it should) but centered on zero with symmetrical sides positive and negative, and a range of 2 to 3 V and maximum output peak to peak.
The amplitude output is not between 9 and 15V as shown the instruction manual.
Someone has this zapper that can tell me if this is normal?
Thank you and greetings
 

 
Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


 

Donate to CureZone


CureZone Newsletter is distributed in partnership with https://www.netatlantic.com


Contact Us - Advertise - Stats

Copyright 1999 - 2021  curezone.us

0.313 sec, (1)